cant change to 4bar mapsensor in TS ?

[Xuri]

hello!

downloaded the latest Tunerstudio yesterday and ran into trouble.
i cant find where to change what typ off mapsensor you have, in earlier version you did it in project properties but now its gone?

[LT401Vette]

TunerStudio hasn't changed on the MAP sensor selection.

What firmware are you using?
Some newer firmwares suppress the settings in Project Properties that were not being used.

[Xuri]

TunerStudio hasn't changed on the MAP sensor selection.

What firmware are you using?
Some newer firmwares suppress the settings in Project Properties that were not being used.

i think it was 2.1.0p pr 2.1.0q or something, i got som error message in MT 2.25.

maybee i can check that later, the car is 20km away

[LT401Vette]

MS2 Extra doesn't use the setting in Project Properties.

[Xuri]

haha whata newbie i am

the car has the newest 3.2.1 firmware now and my mapcomp got upgraded to ts 1.42.

how do i change so the gauge get the 0-400kpa scale?

Best Regards Jens

[LT401Vette]

To change the Gauge:
- Right click on the gauge cluster and select "Designer mode"
- Right the MAP Gauge
- Select: "Properties --> Gauge Limits & Values"

A dialog will open and you can change the 'Maximum Value" to what you need.

[Xuri]

thx!

best regards / Jens